TV47 roadmap

Attic gym

• Create space in attic for gym floor:
  • Clean out used building materials, fiberglass insulation, polystyrene boards, bricks, packaging, etc.
  • Disassemble, decommission, and dispose of insulation box of fiberglass batts around old hot water tank
  • Sort Dominik and Župančičeva stuff; dump/keep as appropriate
  • Move Župančičeva boxes from pile in center of attic to a stack around the perimeter in unused area under sloping roof
  • Process Dominik stuff into keep and dump; dispose of dump stuff, find space for keep stuff
• Install 5m x 5m floating sleeper floor (dimensions matched to standard modular dimensions of OSB panels) to elevate gym floor above concrete and create springiness in floor, shimming as needed to create a level surface
• Purchase OSB panels to use as subfloor
• Install OSB panels on sleepers
• Find and purchase rubber flooring; transport to TV47
• Install rubber flooring onto OSB subfloor
• Move exercise equipment into gym
• Prototype use of "pohištveno železo" as pull-up bar material
• Equipment:
  • Squat rack
  • Exercise balls
  • Pull-up bar
  • TRX cables
  • Foam roller(s)
  • Kneeling psoas strech + quad stretch setup
  • Dumbbells
  • Makeshift gymnastics mat with e.g. mattress springs sandwiched between OSB panels
  • Hip-height hurdles for hurdle combo
  • Shin-height hurdles for footwork
  • Battle ropes or equivalent
  • Lateral balance board to use for balance board combo
  • Rolling balance board to use for balance board combo
  • Extra Bosu
  • Weight rack for plates
  • Dumbbell rack

Kurilnica

• Remove and decomission old electrical wires
• Trace plumbing/heating pipes and identify role of each pipe, pump, valve, etc.
• Clean out old furnace room waste, ash, dust, wood, etc.
• Demolish old styrofoam doors; pack into backs and dispose
• Drain hot water reservoirs and furnace
• Remove plumbing lines and accessories
• Disconnect hot water reservoirs from plumbing; remove and sell
• Disconnect furnace from hot water plumbing; remove and sell

Attic electrical

• ~~Replace east wall plastered-on doza with outlets for gym iPad ~~
• Plan circuit map for wiring
• Purchase materials
• Install conduit, fixtures, etc.
• Install panel
• Install lights at ridge beam for even light distribution
• Contact Dušan to verify before going live

Attic remodel

• Discuss and decide on scope of remodel with family: rough square footage; rooms to include; utilities to include; etc.
• Empty attic of all residual furniture, beds and matresses, Dominik-era stuck stuff, Župančičeva-era stuck stuff, construction waste, pack all loose "to stay" materials in uniform modular cardboard moving boxes
• Decide utilities layout for bathroom
• CAD plans for bathroom, focusing on utilities
• CAD plans for remaining floor plan

Miscellaneous

• Learn wall parging with Zvone; PoC example in pekarna wall
• Laying CMU brick with Zvone; plan for skedenj wall; build wall with Zvone

Ideas

• Learn to sharpen: chainsaw chains, kitchen knives, scythes, sickles, brush cutter blades, chisels, axes, krčun.
• Krušna peč usable
• Pekarna slab
• Wood-burning stove: get to a point where you can use existing wood-burning stove to heat the house if heat pump goes down.
• Make a gym equipped for Ricky MTWT workouts
• In TV47 attic make some exercise toys for climbing around along the beams, e.g. to hand-over-hand like when Randall and I were framing Evelyn powder room.
• Make a platform-framed drying rack to replace rickety attic drying rack and learn platform framing.
• Husqvarna 560 up and running
• Generator: get to a point where if power goes out you know you can frictionlessly restore power to e.g. a few computer outlets, lights, and freezers via generator.
• Tractor up and running
• Learn welding
• Make a wood-framed greenhouse on a pier foundation as an exercise.